Scudhawk. 72 posts 路 Joined 2014. #6 路 May 2, 2015. The dome light in the back seat has an off switch but the front seat map lights have no easy way to be disabled. You can as mentioned remove the bulbs, but there is also a wire that detects when the door is open. I used to have a thread saved for it, wasn't on this forum unfortunately.
and to remove the unit get a small flat scredriver, place it in the fron centre of the light unit up as far as you can between the clear light lens and the dash type frame, then gently push the handle of the screwdriver towards the windscreen. the unit will fold down on the front then just slide out, FORD FOCUS SIDE VIEW MIRROR COVER REMOVAL REPLACEMENT 2011 2012 2013 2014 2015 2016 2017 2018If you have Ford Focus and you need to remove, replace side viewandyholt1 Discussion starter. 1879 posts 路 Joined 2009. #5 路 May 29, 2021. Silverback said: Be careful when removing the vents as the lugs can snap off, a new pair of vents from Ford are over 拢500. OK ta.Hi, my interior light on MK2 focus went weeks back, mechanic gave me a spare bulb when I had mot last week. I replaced bulb but still not working still .. I check fusebox today fuse 104 I think. Robbo. 4749 posts 路 Joined 2007. #3 路 Mar 18, 2018. The gaiter is different though, and I reckon the facelift knob feels daft. The PFL knob feels good in the hand :lmao: I gave up on leather bound knobs, not into bondage :lol: :facepalm: I have a black nylon one with a 6 speed pattern on the top. Never wear out :woohoo: Hello guys new to this and this is my first post which is probaly the easiest fix but thats why were on this site haha. Anyways iv got a mk2.5 59 3DR focus and the interior light in the cieling panel was playing up earlier and wouldnt turn on when the doors were all closed and now after taking the lens off and looking to see if anything was wrong i.e bulbs need replacing there is only one bulb Shop for New Auto Parts at 1AAuto.com http://1aau.to/c/359/i/lighting-interiorIn this video, 1A Auto shows you how to replace a broken, damaged or burnt out It is very easy to remove the console (three screws for me: one in each front cup holder and one in back). Pull the e-brake as far back as possible and I had to put my stick shift in neutral and unsnap the shifter boot. Feed the shifter boot through the hole as you pull it [the center console] up. remove the trim panel btwn the A pillar and the kick panel (pull out from the bottom, then down) remove the B pillar trim panel (pull outwards toward the front of the car near the plastic clip on the bottom), this will pop the clip out. remove that and then pull straight to the center of the car. when putting this back be careful to align the kl9APN.